Printed in Bambu ABS white and tangerine yellow on a P2S and it assembled smoothly with no tools. However the ribs failed to print 3 times until I added an outer brim. Then I printed a second stand in PLA+ white and orange but it was impossible to assemble, even with a hammer and heatgun, most notably the screw-on cap. Also the springs needed an outer brim to print successfully. Had to reprint everything but the orange ribs and side arms in ABS. Therefore knocking off a star. Despite these issues, the design of this stand is outstanding… of note are its wide range of heights and positions, ease of adjustment, a middle gap to allow unobstructed swipe up from the bottom edge, and robustness. I am very confident my tablets are safe on this stand. Thank you!

Excellent for holding small parts. Printed on a P2S in black and white ABS.

Excellent design, easily able to hold my iPad 12 pro securely. I like the wide range of angles from nearly vertical to less than 45°. Strong and sturdy when printed in ABS on a P2S.

Printed well on a P2S using a cheap Ali Express 0.2mm hotend, in black PLA and white ABS.

Solid and sturdy when printed in PLA.