Love this design so much I printed 3 of them with the fuzzy skin. I used Eryone petg-cf Black and LISM petg red for the box with pinuri red tpu95a for the gasket. Note the fuzzy skin prints on the gasket channel if enabled. It made installing the gasket also lot harder. In my case I had to use a box knife to smooth that out so I could install the gasket also i sanded the hinge contact points so they could operate smoothly. That's 100% on me but I love the look and it was worth it.

I modified the size to fit my hardware storage bins and printed then put of lism transparent petg. I was able to breath new life into my donor hardware organizer as I've been stressing bins from it to replace ones in my other units for years. Im considering just printing off enough other bins that this one will all match as they look and work good. A remix with integrated dividers would be a nice addition if possible but overall a great design.

Great design, I played with the quality and infill settings on my print. I lowered the infill to 10% gyroid and lowered the speed/maxed the quality setting + made sure variable layer height was on. I did have tree supports enabled. I used Bambu petg white for the filament. Once the print finished i did a bit of post processing removing supports, only the narrow section at the top of the spool fought me a bit. The print was usable at that point though I opted to sand for a super smooth finish.

Awesome print. I ended up doing a couple and loading them up with ammo to capacity they still feel great. The fit was perfect and it isn't flexing or feeling cheap even fully loaded. Printed with Lism petg black and bronze on a p1s.