Easy, fairly quick and doesn't take up much shelf real estate.

Handy clip. Printed in Bambu Translucent Red PLA.

Neat model. I printed it in PETG HF. I'll use the printed spring until it fails then check out your banding steel alternative.

Surprisingly strong. I printed hangers for two complete sets of armor and they're working well though I did have to reprint one arm that broke at the joint when the hanger was dropped and it took a shock load on the z axis. Pretty sure I can remedy that by printing some supports that will also mure closely mimic the natural angle of the trapezius muscle. printed in PETG with 65% infill.

Nice to have a collection of different sizes and styles in one place.

Easy and quick. Frankly, I'm surprised the factory doesn't put some kind of a protective grate over the fan but this works well.

Printed quick and easy and they're very handy.

Qwerky and fun but I think I'll print some more with 100% infil as the first set just feels too light.

The wife is into owls so I printed this as a gift to her. She loves it.

They printed with no problems and work great.

Handy box for misc tools and parts.

Cool spool.

Works really well but could stand to have an even higher wall portion in the center. For some reason the A1 sits really high on the Z axis when kicking out that first ball-o-poop after loading a new filament.

Neat, little clips that are not dependent on the type of spool the filament is wound on.

Fantastic model. My only complaint would be that the locating pins are very, very fragile and are practically guaranteed to break. Perhaps print them in a tougher filament or substitute metal pins.