Works like a charm in the Skroam Müsli Boxes! Is it possible to slightly redesign the model to eliminate the need for supports though? I'd like to print this silica box a few times for all my filaments and would prefer this model then, as it consumes relatively little amounts of filament while being able to house enough silica for one filament box. Without the supports it would be even less material spent. Thanks! ☺️

Great alternative model design for the box that saves filament but is still holding the cubes together just fine while being easy to attach and detach :)

Great quality, fits snug with the table mount

The wheels' tolerances for each tooth of the gear could've been slightly tighter to allow for less movement inside each digit. However, it still works great and was so easy to put together (easier than competitors)! :)

I feared it wouldn't fit but I just had to press the hygrometer well into the printed ring. It fits snug into the lid but not too tight in case I wanna remove it. Great model!

Love it! Very high quality model, prints just fine! There was some gllue needed for the letters to be sticking to the 'balance board semicircle' but that was easily done. Can't wait to play it with friends & family! Edit: Family was sceptical at first but then loved it! Very entertaining! :)

Great model, great gift that's something different but the 100th toy someone already has

Great game to play among generations! Just played it with family, three generations. A bit tricky for people 80+ but everyone enjoys it 👌🏼

Great game with a ridiculously easy gameplay that captivates friends and family! I have been taking the dices to a lot of occasions and everyone got addicted to play. Have only printed the dices yet though, not the Tower or the cup as it was too big of an amount of filament for me so far. I printed two collapsible dice towers from MakerWorld for to-go use though. Also, I experimented with the flushing settings in Bambu Studio so the whopping 100+ grams of filament just for flushing the colors gets reduced to just 10-15g. I changed the multiplier to something around 0.3 for that I think. Already printed 5 sets of dice and won't stop just yet. Been playing the original rules until yesterday but with 90 seconds timer and starting with categories now (which is even tougher) :)

Love the game design and the model! I printed all the letter pieces too, thanks to both contributors below this model! Much fun to play, more than Wordle itself. Wish the base box would be able to fit 10 pieces of every letter though, that's my current amount of letter pieces for the guesser. Also, I didn't want to print the whole thing again for the game master (who makes up the word) as that's quite some more filament. Right now I'm using a bag and slightly differently colored letter pieces for the game master but I wish it was a box fitting to the base one (and I'm too inexperienced in Fusion to rework it myself). Still a great model! :)

Great base model! I recolored the leaf in Bambu Studio on its top and bottom in green to be printed with AMS. tripled the print time but it improves the look. together with an articulated snake this makes a great combination for a party theme

great model! I colored the eyes afterwards with a black sharpie. used an apple model from here for a party theme

looking great!

easy to print & to peel off the supports, looks fun