keep getting layer shifting towards the top of my prints on my A1 Any thing above 220mm high and it layer shifts on the Z. Anyone else getting this? how did you sort it out?

Vibration. Anyone else getting serious vibration on curvy corners? my A1 was never noisy but the last few prints, Its making bad vibes on all the curves. It quite on the straights but so noisy through vibration on the curves. I run the full set up each time so i'm baffled ??

Having a laugh with ASA, Itss not happy at all. 14hrs in the dryer, heated chamber, Fans on super low and it lifts and pops off. So, tabs with Magnets. tried tape first but then realised I had magnets. seems to have worked out fairly. not funished print yet but.....