Great if you don't have cases in your devices

Nice and sturdy

Such a useful print I've printed a few now thankyou

Great print a little figity to get it clamped (need some strength behind you) and the pin needed to be hammered in the only issue I have is the ptfe tubes will knock into and shake the camera everytime the nozzle goes to the right side of the plate going to see if I can find somthing to help that (if you have ideas that would be great)

Great print supports came of easily minimal scaring thanks

Great useful print thankyou

Such a useful print can't wait to not cook too much spaghetti

The bowl part printed amazingly unfortunately the handle snapped with very little pressure when screwing it in (didn't get it all the way in) I think it would be better if it was printed as one piece

So cute will be using them as our crow statues Valentines day costumes 😂

Supports weren't that easy to get off took me about 40 minutes but still looks amazing can't wait to paint it

Great solution to annoying cords that won't stay where you want them

Great print and super useful added the end connector cause I missed the length by a little bit haha just had to make it a bit longer thanks heaps

Can't have the faceplate on the PowerPoint but works great and I'm OK with it being off as you can't see it anyway

Not sure if it's somthing I did but the whole thing was fused together and when trying to release it they just snapped

Kids loved them

Too late to go out to the sand pit but definitely a quality build thankyou

Only negative I have is that they are a balancing act to stack

I measured my lights witch and the measurements were smaller than the smallest one so I printed the smaller one and was going to stick it on turns out its smaller than my switch will try printing the larger one see how that goes