Excellent design! Can't wait to try it out with the nieces and nephews!

This came out great! I decided to print in sparkle PLA which presented a few challenges, but i was able to adjust accordingly. Super great model and highly recommend!

This is so cute! I chose to print with silk PLA so I slowed down my print quite a bit. I also increased walls on the outside and used fewer on the inside piece. Slides in and out well and came out quite smooth. Love it! 🩷🩵

I love the modern look of these roses. I printed with translucent pla and slowed down the print so it took a bit longer. It was well worth it!

The vase is super cute and it came out great! I was only able to fit a few faux flowers but I don't think it is meant to be top heavy due to too many flowers. I used matte filaments and the supports were easy to remove. Overall, a super cute and great print!!

The design is lovely! I printed in a pink silk pla and it turned out well with a few challenges. The supports are intense and under the headphone holder was a bit stringy so I will need to sand it. Fortunately, these spots are underneath so they are not as visible. Overall, it looks great!

Fantastic print and excellent quality. Looking forward to printing more!

Printed using luminous filament. Looks great!

Thank you for the wonderful design! I printed this on an A1 and it overall it printed well, I had to adjust the sizing which changed the angle so the heel wasn't as smooth as I would have liked but that is most likely an error on my part. I used TPU 95A and lowered the infill to 12% to make it more malleable and added inserts (not pictured) for arch support and rubber soles to prevent slippage. A challenge I had was that the pieces that hold the strap to the shoe do not stay well, so I have had to glue them together. Overall, a great design. Thanks again!

Thank you for the lovely design! I liked the fact that I could adjust the negative space to accommodate my washers. The size listed in the profile was a little challenging to find so I used slightly smaller ones with a slightly larger inner hole (~50.8mm x 50.8mm x 2.54mm). It wasn't heavy enough so I glued 4 together and adjusted the negative space, the size of the doughnut, and pause time to accommodate the weights. As the design can be printed multicolour and it is in one piece, it does produce a lot of filament waste. I mixed filament types (matte, silk, standard, translucent, celestial) and it worked well, but it did require some tweaks to the profile to get smoother edges. Highly recommend to slow down the print if you are printing with Silk. Overall, be prepared to adjust settings and expect a lot of filament waste but it is an adorable and functional print that I will print again!

Looks and works great! Printed quite snappy on my A1 in PLA.

The print is long but it is worth it! I use PLA on the A1 but I do find that I have to sanding the inside a bit as it is smidgen rough around the holes.

Fantastic bin! I printed the bin in PLA Matte Plum and the inside mesh and attachment in Turquoise. Looks and works great!

This was a solid print and it was so cute! it had a few hard to remove pieces on the bottom so sanding was required. I used a purple silk PLA and printed on the A1 Combo. I am new to this so it wws most likely something I needed to adjust. Thanks for a great design!