Samurai Tea Bag Holder
Copyright Claim
Samurai Tea Bag Holder
Boost
50
107
20
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
1 h
1 plate
FIXED NON MANIFOLD AREAS 0.2mm layer, 3 walls, 15% infill improved supports
1.3 h
1 plate
Open in Bambu Studio
Boost
50
107
20
0
168
214
Released
Comment & Rating (20)
All
incorrect joint tolerances
The designer has replied
0
Reply
The joints are not fitting together and must be glued if it needs to fit on all types of mug. Thanks
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
love it!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
the rod should be a little sturdier - other than cool looking dude
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Its Good
0
Reply
Print Profile
FIXED NON MANIFOLD AREAS 0.2mm layer, 3 walls, 15% infill improved supports
0
Reply
Print Profile
FIXED NON MANIFOLD AREAS 0.2mm layer, 3 walls, 15% infill improved supports
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld