door stop
Copyright Claim
door stop
Boost
20
33
21
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
43 min
1 plate
Open in Bambu Studio
Boost
20
33
21
1
208
191
Released
Comment & Rating (21)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
Came out pretty nice to be honest. I had a bit of stringing which along with some print artifacts which I think is more down to my filament being old rather than the print profile being the root cause.
(Edited)
The designer has replied
0
Reply
I'm very happy that you liked my project, a soft TPU version will also arrive shortly for better grip on the ground
0
Reply
Replying to @thedecember87
I have mine on the carpet and I find it grips pretty good in all honesty. The TPU version will be a very handy addition for hard flooring which I have in abundance in my house too :). Your model is structurally nice and strong and beats the previous version of door stop I had by a country mile which broke in the end.
0
Reply
Replying to @BertBee
I am very happy that you liked it and I will soon make the revised and updated TPU version for smooth floors as easy and quick as possible to print, if you like you can follow me and I will add it to this profile shortly
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Printed in ludicrous mode.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
works havo
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Funktioniert wunderbar und hält nun Türen offen...
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld