Came out very nice, thx you for the model!

success!! just set up my new desk and needed a spot for my watch to charge printed this off and its perfect

fits very well. was a bit concerned on how the charging surface would secure in UT, but I need not have concerned myself - fit really well. I did end up cutting the the height of the lettering down as it seemed overly excessive. I think a mod II would make to it would be just some slight long 1/8"-1/4" protusions along the cable path (offset from each other) to securely lock the cable on position. not that they're falling out, but the cable does not sit down in the recess completely through the whole run. well done on the model, I do like it and thanks for sharing!!