This is full verison of the pistion trophy design. Full size , Bore dia 98mm. There are major feature changes from the semi-assembled one. The piston rod position have 15 degree to 30 degree max angle adjustbility from vertical center line. Pistion have 60degrees adjustbility from horizontal surface. All the connection part will have tight fit by design so you could keep it in position after adjustment.
The dripping overhang issue is also taken consider during design process, by the orientation that I put on print file, these amount of overhang will work as friction component to keep the over all fitting tolerancing. At the same time those ugly overhang is not visiable to you after assembled. So, good deal. To proof there is attention to detail on my work, lol. (If your filament have huge sinkage rate, it might cause issue.)
There is no other hardware required. All parts are printable, but you will need to assembly it yourself.
I made different print files for different color setting. Introduction is below. It would be a great little build project with kids.
Tag is interchangeable.
Have fun!
Due to the different material sinkage rate are different, I have tested many different revision of bolts sizes, but most of them end up hard to assembly, or break eaily for silk filament . At the end, I have decided to change the bolt to pin. All the pins are designed to be tight fit. You may need to hammer it down a little bit.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.