Phone Stand with Cable Management (No Supports)
Copyright Claim
Phone Stand with Cable Management (No Supports)
Boost
59
93
39
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Phone Stand Upper 0.2mm layer, 2 walls, 15% infill
Designer
55 min
1 plate
Phone stand lower 0.2mm layer, 2 walls, 15% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
59
93
39
1
283
183
Released
Description
Simple phone stand which is made of 2 parts.
Print both parts and the slide them together, the stand works like a charm and should hold by itself, if not you can add a little bit of super glue to hold i together. If it's not glued together you can take it apart and travel with it easily!
The stand has been designed with holes for the cable to exit out the back.
If your phone does not fit on it or the cable doesn't fit please let me know and i will see if i can get another version made.
Check out my other phone stand!
Comment & Rating (39)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
This a great little stand. I used some generic black silk pla and it printed very well.
The designer has replied
0
Reply
Thank you for the boost and I’m glad you like it🤝🏼
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print, everything fits snug and had no impurities whatsoever!
The designer has replied
0
Reply
Glad you like it! Thank you for the rating.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
on tho bottom are issues
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This was my first PLA-CF print came out great. It went together nice and snug. Printed on the sample roll that came with my new X1. Samsung S23 Ultra with Otter box case fit well, Thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed Mint
The designer has replied
1
Reply
Thanks for the rating :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I added rubber feet to the bottom
The designer has replied
1
Reply
Nice idea! Do you have a picture? :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works as described
1
Reply
Print Profile
Phone Stand Upper 0.2mm layer, 2 walls, 15% infill
I added more walls just for security and strength and it printed great
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works great I like it
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld