Search models, users, collections, and posts
Origami Crane
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
45 min
1 plate
Open in Bambu Studio
Boost
1453
3892
362
132
4.9 k
3.7 k
Released
Description
This is a remix of a origami crane from thingiverse to add two holes in the model so it can be hung as an ornament or any other application. Holes were added at 90 degree intersections so it can be hung from any angle you would like. This model prints without the need for any supports. Fusion 360 was used to remix the model.
If you like this model, check out the Origami Rabbit: https://makerworld.com/en/models/98647#profileId-105179
and the Origami Tortoise: https://makerworld.com/en/models/98663#profileId-105199
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (362)