YuGiOh Modular Deck Box
Copyright Claim
YuGiOh Modular Deck Box
Boost
6
16
4
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
23.2 h
5 plates
Open in Bambu Studio
Boost
6
16
4
0
32
18
Released
Description
A simple modular deck box for people who have a lot of decks to carry around. It uses an 8x3mm magnet to stay together. I know it's not perfect, but it's my first project.
Comment & Rating (4)
All
I printed it and its perfect, but how did you get the lid on the box?
The designer has replied
1
Reply
you can use a piece of filament
0
Reply
Replying to @stubby
Yeah, as @stubby said, use a piece of filament a little longer than the lid's length (make sure that there is a bit of filament sticking out from both sides) and use a lighter to melt the two sides to make a blob of filament on either side, and Viola! You have your lid attached to the box! (the explanation is long, but it is a short process I promise [if you know how to handle a lighter responsibly])
-ozimandius_117 @ozimandius_117
1
Reply
does this fit cards with protectors/ sleeves? and how many cards can fit per box?
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld