This a revamped and improved version of an already existing filament bracket.
Very easy to mount: you just need T nuts and bolts from the original metal bracket.
The 4 bolts are a very tight fit, this is in order to keep the filament sensor steady.
I highly recommend printing this in Pet,but pla also works just fine.
This will kill a bit of your Z print height, since if you're printing too high, the filament will have too much friction when going to the sides of the X axis.
I also made a version that uses bearings on top of the filament sensor, so it doesn't kill any print height.
Resolution:
0.2mm
Infill:
100%
Filament:
Esun PETG white
Notes: