Umbrella Key Holder Magnet (6x3 magnets)
Umbrella Key Holder Magnet (6x3 magnets)
Boost
19
47
1
Print Profile(3)
Single colour
Designer
1.2 h
1 plate
Multi-colour, two plates (to reduce the purge waste)
Designer
6.5 h
2 plates
Multi-colour on one plate
Designer
7 h
1 plate
Open in Bambu Studio
Boost
19
47
1
0
48
16
Released
Description
A cute little key holder magnet for your kitchen.
Simply insert 5 magents (6x3 like these (affliate) they will press fit into place) and slide the handle in (You might even like to add a dab of glue at the top, but this is not necessary) and you are good to go!
UPDATE!
I am very happy to say that my model was used to demonstrate Bambu Lab's new PLA Dynamic Filament (And their picture is much better than mine):
Comment & Rating (1)
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld