Search models, users, collections, and posts
MFT Table Adjustable Stop
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
2 h
2 plates
Open in Bambu Studio
Boost
58
287
4
0
147
68
Released
Description
Adjustable stop for use on an MFT, or compatible, table-top w/ 20mm Dog Holes w/ 96mm spacing. This one is sized to be going over 2 spaces with an adjustable range of 192 mm. Printed in PETG HF - although expect other filaments will be fine assuming your printer is tuned properly (as sizing is critical for the dog holes).
You need to install at least one M5 Threaded insert into the base (although 2 can be convenient for reversing the top without having to remove the base from the table) - I used these https://www.amazon.ca/dp/B0CS6WFCGZ
You will also need an M5 knob (and possibly washer) to hold the sliding top in place on the base.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)