this is a small trailer for the Orlandoo Hunter.

I designed it to implement some leftover parts from my Orlandoo Jeep kit.

What you'll need:

5 pc of OHSW01505 screw(4 for the axle carrier and one for mouting the towbar to the truck's rear bumper)

1 pc of OHSW01205 screw(for the ball end)

1 pc of OHMLA20162 ball, and a corresponding ball end

2 small wheels. you can use anything up to about 31mm OD.

a 2mm rod for shaft.

Some more details:

I used a pair of Losi Micro-T front tire. to mount it, i needed a 2mm steel shaft, about 62mm long, with 3mm thread on each end. You can also use an M2 threaded rod too. I installed the wheels inside out, because this way the trailer is a bit narrower overall. I also needed some 2.5mm spacer between the wheels and the trailer on the shaft, so the tires won't rub against the wheel arch. finally, to lock the wheels to the axle, i used two M2 nylon locknuts. Also I reinforced the ball end with a bit of superglue around the 1205 screw. To mount the towbar, i drilled a 1mm hole to the middle of the rear bumper