Introduction

I wanted to have a more comfortable experience playing old Atari (2600, XL/XE) games on original HW. Atari's own CX40 never felt so good, so I created my own.

You can also find attached a zip archive containing the necessary gerber files for PCBWay in order to assemble your controller.

Necessary Parts

1x Sanwa Denshi Joystick with Base (JLX-TP-8YT-SK)

1x Sanwa Denshi 24mm Push Button (OBSC24)

1x Sanwa Denshi Clear Bat Top (LB30N, or equivalent)

1x Joystick wiring board (attached to “Other Parts”)

1x Atari controller extension cord

2x M3x8 (to attach wiring board

4x M3 Nuts (2.4mm thick. 2 below the wiring board, 2 above the wiring board)

4x M3x12 (to secure the lid)

4x M5x12 Carriage bolts (to secure Sanwa Joystick) 

4x Nuts for the carriage bolts

4x Adhesive rubber feet

Wires and crimpers as necessary.

!!!!!!!!!!!!!!!!!!!! WARNING !!!!!!!!!!!!!!!!!!!!

Even though the render of the PCB shows upright/vertical pin headers, make sure to use horizontal/90 degree bent headers otherwise the joystick will not have enough clearance to sit within the enclosure.

!!!!!!!!!!!!!!!!!!!! NOTICE !!!!!!!!!!!!!!!!!!!!

Make sure to download the Gerbers for the joystick adapter board.

Disclaimer

The information provided here is for general informational purposes only. All information is provided in good faith, however we make no representation or warranty of any kind, express or implied, regarding the accuracy, adequacy, validity, reliability, availability, or completeness of any information here. UNDER NO CIRCUMSTANCE SHALL WE HAVE ANY LIABILITY TO YOU FOR ANY LOSS OR DAMAGE OF ANY KIND INCURRED AS A RESULT OF THE USE OF OR RELIANCE ON ANY INFORMATION PROVIDED ON THE SITE. YOUR USE OF THE SITE AND YOUR RELIANCE ON ANY INFORMATION ON THE SITE IS SOLELY AT YOUR OWN RISK.