Fidget Tri-Spinner 608 Bearing
Copyright Claim
Fidget Tri-Spinner 608 Bearing
Boost
15
45
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
24 min
1 plate
Open in Bambu Studio
Boost
15
45
16
1
128
90
Released
Description
Tri-spinner without the Knurl.
The caps in the spinner work great for me, but other people have complained. So here is a link to another set of caps that work well too.
Print Settings
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
75%
Documentation (1)
Other Files (1)
SOURCES.txt
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect fit
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Try 3 different types of bearing and they all fitted well. Suggest to lower the layer height near the top and bottom to get a smoother print.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed smooth and the bearings fit the spinmer perfectly. sadly, my bearing inner rings are too large for the other two pieces to snap on.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works, but a bit tight for the bearing I had.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Simple print that was easy to run. As noted the inner buttons are slightly fiddly but I managed to position them well with the 3D printed bearings I found and works fine.
0
Reply
does this work with 3d printed bearings
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fidget spinner
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great. fast and easy print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld