Honda CRX Cup Holder

This was designed for the 1989 Honda CRX SI, I am not sure how well it will fit in other CRX's or Civics.  

The cup holders are about 80mm in diameter and should fit most standard cups just fine.  In order to not interfere with the seat recline the cup holders are fairly close together so there could be clearance issues if you are trying to hold two very large cups at the same time

This is designed to print without supports, and came out pretty well for me in the orientation shown in my 3mf. I strongly recommend using ASA or similar to avoid warping from heat or degradation from UV rays.

Final note of caution: the model is only held in place by gravity and friction. It has been completely stable for me so far but I would advise testing more “aggressive” driving styles with completely sealed bottles first to prevent spills.