Secret Lab Chair Cup Holder
Secret Lab Chair Cup Holder
Boost
19
40
5
Print Profile(1)
0.28mm layer, 3 walls, 25% infill
Designer
3.4 h
2 plates
Open in Bambu Studio
Boost
19
40
5
2
30
23
Released
Description
'm using Secret Lab EVO XL 2022. I'm not sure about compatibility with other versions.
PRINTING
Energy drink insert is optional. You can scale the z dimensions if you want more or less security. Or you can print two and stack them. A red bull 16oz should fit. Still works as a regular cup/bottle holder while the insert is installed.
The color accent was made with Bambu slicer which is setup in the 3mf file. Match your chairs theme. I also used 15% support cubic infill. 0.28 layer height works.
INSTALLING
There is a slope to the chair arm so there will be more gap in the brackets if you install higher. And less towards the bottom. Very bottom may require some foam or rubber inserted.
Comment & Rating (5)
All
Print Profile
0.28mm layer, 3 walls, 25% infill
it’s works as is, but I think I’d feel more comfortable if I added another wall or two, or increased the infill a little bit.
I really like the insert for smaller drinks. great idea
The designer has replied
1
Reply
Those are good suggestions, updated print profile.
0
Reply
Print Profile
0.28mm layer, 3 walls, 25% infill
fits perfect thank you
1
Reply
Boosted
Print Profile
0.28mm layer, 3 walls, 25% infill
fit perfectly
0
Reply
Print Profile
0.28mm layer, 3 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld