Search models, users, collections, and posts
Berley Float
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.3 h
2 plates
Open in Bambu Studio
Boost
12
25
3
0
25
12
Released
Description
I needed a Berley Float to fish with, the available models at the shop were expensive, flimsy and too light to cast.
The Caps are hollow, I used PLA. The Barrel has 15% infill, seemed OK and floated well.
The caps are a little difficult to get off but that ensures they will stay there, a little practice and they go and off a bit easier. Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)