Sim Racing Wheel button plate for Moza bases

So I designed a button plate for ten buttons (+ horn) and two paddle shifters for a Moza v2 base and quick release.

All printed in black PLA on textured PEI, no special settings. 

For the button covers/holder I used a PEO plate with a carbon fiber texture.

I needed the spacer because my cables were a bit higher than the cable channels. Cable management in general is a bit finicky.

The microcontroller enclosure is designed for an ESP32, which can also use the base's 12V directly.

The upper two button covers were designed to hold  threaded inserts, but the ones I was using were too big and collided with the chassis. The covers themselves had a tight fitment to the chassis, so the inserts/bolts weren't needed.

See here for more info: https://www.reddit.com/r/moza/comments/1fv53w7/custom_wireless_button_plate/