Thread Scissors - Gridfinity

This was a tricky one to make.  I wanted a low profile scissors holder for the thread scissors I use in leathermaking.  I wanted it to be the smalles footprint possible while holding three sets of scissors AND fit into the top of my Kobalt Mini Toolbox with the lid closed

I was able to achieve this by using a 1x2x2u Gridfinity Bin.  The cutouts for the scissors go down as far as possible while allowing the bin to be sturdy.  As you can see in the picture, there is no material between the grid squares in the scissors cutouts

Also of note is the orientation in which the scissors must be placed.  Notice in this picture that there is an inside and an outside at the butt end (hinge) of the scissors.  The inside is narrower than the outside and this must be placed down in the Bin.