Millennium Falcon Nest Mini Holder

Remixed by

Millennium Falcon Nest Mini Holder

Remixed by
Boost
63
94
19

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 4 walls, 15% infill
0.2mm layer, 4 walls, 15% infill
Designer
3.1 h
1 plate
5.0(16)

Boost
63
94
19
2
101
98
Released

Description

This is a fun and relatively simple star wars themed Google Home Mini holder. It does require supports to print but does fit any model of the Mini that you might have. Hope you enjoy!

 

I changed up some of the file to make it easier to print. All thanks to the original modeler :)

Comment & Rating (19)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 4 walls, 15% infill
That’s 100% fun model to print 😁
The designer has replied
1
Reply
looks like I was just as here at home. enjoy!
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Really cool fun model, the underside struggles a little after removing the supports but thats the overhangs and support tuning not the model or design!
0
Reply
Why cant i rate this ? hmm - Printed quality is good and I like the model and functionality, mouted vertically on my wall now. Only wierd thing is, it does a slow circular pass around the centre, but then does this HARD short acceleration, very aggressive -so much so it rattles the rods and vibrates the hell out of my X1C. Anyone else get that? Its only in 1 spot, affter it finishes doing the circle "laps" that seem to slow down. Video here with the noise\sound - https://youtube.com/shorts/BI7SlRwusTU
(Edited)
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Came out great
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Perfect for the living room. only better would be Deep Space 9 😁
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
awesome
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
wish it leaves a bit more space for the outer edge around the hole for the cable to run through
(Edited)
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
awesome little model. thanks
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Fits my Google home mini perfectly.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
had trouble with the lower outer wall layers but that's my fault. got it to work eventually by printing slower
0
Reply