Virtual shelf for food box

Copyright Claim

Virtual shelf for food box

Boost
24
44
3

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
5.9 h
1 plate
5.0(2)

Boost
24
44
3
0
31
11
Released

Description

I put cat food into foodbox, which is another space eater… until now. I can hang it /shelf it in the cabinet.

Design is for screws, but why not to use double-side-tape?

Be aware that .16 layer pushes on the prints resulting in colapse… brims may not be necessary, frankly I hate them, but… why not to stick on safe side?

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Great print. It did require a tiny bit of cleanup once finished, as there were a little wispy hair-like pieces in between the hexagons and also at the back, but it was very easy to do. The sides where the screws/glue go also happen to fit Gorilla double-sided tape strips perfectly - great if you don’t want to screw into your shelves/cabinets. It feels sturdy. this one is holding all of my cutting boards on the underside of my kitchen cabinet.
(Edited)
The designer has replied
1
Reply
Excelent. Enjoy... If you would like some modification, do not hesitate to write 😉 I am about to prepare a A5 version with tilted end part... Soon.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more