Search models, users, collections, and posts
Soap dish
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
20 min
1 plate
Open in Bambu Studio
Boost
0
0
1
0
4
3
Released
Description
Content has been automatically translated.
Every time a bar of soap is used and placed back in the soap dish, there is a risk that the soap will sit in water. Unfortunately, most soap dishes do not offer sufficiently good support for the soap. In most soap dishes, the contact surfaces are too large, causing the soap to always be damaged.
It was important to me to design a holder in which the soap rests only on very small points. In addition, this holder must fit into a soap dish. Once it is in the soap dish, there should be as large a distance as possible to the bottom of the dish so that any residual water does not touch the soap. The model was deliberately filled to 100% so that it can also be adapted to a soap dish.
Boost Me (for free)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)