Search models, users, collections, and posts
Cairn
IP Report
Print Profile(2)
0.16mm layer, 2 walls, 10% infill
Designer
8.7 h
1 plate
0.16mm layer, 2 walls, 5% infill
Designer
10.8 h
1 plate
Open in Bambu Studio
Boost
64
150
10
2
70
24
Released
Description
This was originally intended as a small terrain piece for a table top game done in resin. One of my kids asked for a larger one for her desk, so we tried it in FDM. I think it turned out ok, not super happy with the supports personally. If printed with my normal support profile the overhangs aren't great, adding more supports to it ended up making them more difficult to remove. No one likes difficult support removal. If it gets popular enough I'll revisit the sculpt and adjust the angles to eliminate the support issue. Hope you enjoy it!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)