Rack & Worm Linear Slide by LoboCNC

LoboCNC

Education>Engineering

Print Profile(0)

Add the first print profile to earn points

Boost

Released

Description

This linear slide could be used for positioning optical elements or the like. The 6" linear rail sections can be mounted end-to-end to create any length rail system. The rails mount with #6 screws on 2" centers, and there are various #6 screw hole patterns on the carriage for attaching fixtures. Please refer to the included STEP file for additional details.

Print Settings

Printer:

UDIO

Rafts:

Supports:

Resolution:

0.2mm

Infill:

20%

Filament:

Inland PLA

Dandelion Yellow

Notes:

The worm piece has an integral breakaway support piece, so you shouldn't need to turn on supports. Just break away the ring that fills the gap between the knob and the worm gear after printing.

Once printed, clean everything up, apply a little grease to the worm and bearing surfaces and insert the worm into the carriage as shown. Then slide the carriage onto the rail, turning the knob ass you go.

Category: Engineering

thingiverse

linearslide