Stand for Photo 3D
Stand for Photo 3D
Boost
15
17
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
15
17
5
0
46
50
Released
Description
Easy to Assemble and Disassemble
The stand is designed to be easily assembled and disassembled, facilitating transportation and storage. The components are intuitively interconnected, allowing for quick setup before the event and effortless disassembly after use.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
It's not bad but it could be better. The top pin is too long. If placed on a smooth surface, it will not hold upright and will end up falling. There could be a way to get stuck. The back leg, the base should be parallel to the ground for better grip.
Other Issues:If placed on a smooth surface it will not hold.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect stand for my hueforge prints thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked a treat!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld