Card Hand Holder
Copyright Claim
Card Hand Holder
Boost
38
74
10
Print Profile(1)
0.2mm layer, 6 walls, 15% infill 2 HALF
4.6 h
1 plate
Open in Bambu Studio
Boost
38
74
10
3
132
66
Released
Description
Couldn’t find a holder for a hand of cards I loved so made my own. Goal was to balance ease of use and visibility while being as minimal as possible. Works with both sleeved and non-sleeved cards. Scale it horizontally to fit your preference or printer’s dimensions. I prefer 300mm wide which holds 5 cards side by side. For more compactness, about 240mm works great for 4 cards wide.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 6 walls, 15% infill 2 HALF
Perfect for holding me and my family's UNO cards The kids especially, just lay them all over the ground for everyone to see. Minimal design as well. Only about 30g's at 15% infill. Other designs I looked at used up to 150g at the same infill. Too much. Thanks for this
1
Reply
which file is which length holder, and does it print vertical?
The designer has replied
0
Reply
There's a few different sizes, but honestly they're all essentially identical. Feel free to scale the holder to whichever size you prefer in your slicer program as you see fit
0
Reply
Would this fit something the thickness of a credit card?
The designer has replied
0
Reply
I just tried a few of my wallet cards, and yes—they fit fine!
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill 2 HALF
1
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill 2 HALF
1
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill 2 HALF
1
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill 2 HALF
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill 2 HALF
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld