Introduction

Introducing the Ergo Spatula that not only helps removing that purged and calibration filament effectively from the build plate, but also boasts a visually appealing design, belonging to the ergo line that offers a unique blend of form and function.

More Items from the Ergo Line:

• Ergo Scraper
• Ergo Envirocontrol

This spatula, does not feature a metallic blade, so do not expect the same performance of a true scraper, if that is what you are looking for, than I suggest this one:

• Ergo Scraper

The smaller the nozzle diameter the sharpest the edge will be. But, if you don't have a nozzle of around 0,2mm in diameter, it's best to use a piece of sandpaper, above 300, and sand the edge at a shallow angle (around 5 to 15º), until it's ok to you. always make a movement transversal (perpendicular) to the print layers direction when sanding.

For a small help, use this affiliate link to buy filament, it will cost you the same. Thanks !

Filaments used on this project