Cube Gear *fidget*

Remixed by

Cube Gear *fidget*

Remixed by
Boost
74
146
52

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.08mm layer, 2 walls, 15% infill
0.08mm layer, 2 walls, 15% infill
Designer
4.2 h
2 plates
4.8(33)

Quicker rotation, 0.2mm layer, 2 walls, 15% infill
Quicker rotation, 0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
2 plates
4.7(13)

Boost
74
146
52
5
295
488
Released

Description

Based on this thing: 213946. Also found on Printables 240274. I was surprised to not see one on here so here it is.

 

Blank model, dropped onto two plates.

I printed gears in Extra fine default settings, and then the pins and center in Strength. No support needed. If you have adhesion issues add a brim.

I have made a lot of these, people at my work love them. I add a bit of lithium grease on each pin before inserting to make it easier to spin in the beginning. The more you spin this the smoother it gets, I have one on my desk for about 2 years now and it's super smooth.

 

8 pins, 4 small gears, 4 big gears, and 1 center piece. I'll pop all 8 pins into the center piece. Then start with the larger gears, get proper alignment as you go and before you click in the last gear.

Comment & Rating (52)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
Printed perfectly and once assembled and broken in it works wonderfully
2
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
great print, works good without gluing. we are having a lot of fun with this.
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Prima parte stampata, la seconda ancora è in stampa. Un bel modello bravo 👏 stampato senza problemi con petg
(Edited)
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Thanks !
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Great toy, turns without lubrication. One comment is that the corners could be rounded (not sharp)
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
after 2nd circle of function, friction was smoothen out and it rolls like a champ
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Printed smooth in PLA silk… nice.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
perfect fit.
0
Reply
Print Profile
Quicker rotation, 0.2mm layer, 2 walls, 15% infill
turned out great at 80% 👍
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Turned out great and turns smoothly even without any lube!
0
Reply