Just got done printing this, turned out awesome. I had one failure printing plate 8 standing up, layed them down and reprinted. The Mechazilla arms printed, but the support arms coming from the bottom turned out pretty bad. Definitely could be my printer and I used PETG,may reprint them using PLA. If I did it again I may use Silver PLA Silk on the white parts to add some color. Awesome model great work jakubroch8!
what plate is this happening? I want to print it also, so I want to make sure that I fix this miss print. And if you have problems with your adhesion then the bed temp is too low or too high for the used filament. You can also use a 5 or 10 ring brim for extra adhesion. You can also buy 3d-lac for better adhesion.
Just finished and it turned out amazing! I used Overture silver silk and black PLAs. And for assembly, I used Gorilla gel glue. Not my favorite glue, but it is what I had on hand and it worked just fine.
I printed on A1 and I had to move the elevator supports (the parts that have pins) and the fins to their own plates and print with brims as that plate failed twice.
I also wish there were assembly instructions. However, just a fantastic model. Great job!
are there instructions? pins to hold things together? do I glue it? printed it all and am lost. p.s. don't print plate 8 with pets. it falls over every time I tried(3).
How many of each connector piece are needed ? I Just finished printing everything and I'm planning on giving it to my nephew later today as an extra christmas gift. He lives abroad so it will probably be assembled at home where i can't print parts on demand.