Search models, users, collections, and posts
support cable usb
IP Report
Print Profile(1)
0.12mm layer, 3 walls, 15% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
3
3
0
0
13
7
Released
Description
Content has been automatically translated.
A small, unpretentious support that can hold up to four USB cables.
It attaches to the underside of a table using three screws (one in the middle is sufficient); I used 3.5 x 16mm screws
or optionally with double-sided tape (untested, therefore unapproved... at your own risk)
There is a slight offset to allow the support to lie flat against the edge of the table.
The cable insertion notch is 4.5 mm, the central hole is 7 mm. This should accommodate, I think, most USB cables.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)