Philips Hue Play VESA 100 Mount Arm Bewiser S1020

This is a Remix of the model:

https://makerworld.com/en/models/482332#profileId-394293

To be able to use it on the Bewiser S1020 monitor stand with VESA 100 connection, the original design was too thick and could not be fixed to the screws, so I reduced the thickness to 7.95mm to be able to use it.

Hue play support is also present in the print profile.

As per the description of the original project, the screws to be used are the following:

Game Bar Connection: M3x8mm supplied with the Game Bar

Connection to pivot point – M4 x 20mm or longer

Monitor connection: M4 x 12mm or M4 x 16mm length may vary depending on your monitor

⚠ Set up your filament well, perform calibrations, dry it and set the right cooling parameters.

I take no responsibility for the print quality of your filaments ⚠