Sitting Skull Bunny Mashup

⚠️ If you want to see all my models (i.e. middle fingers), turn on nsfw in your account settings under preferences⚠️

Hey everyone.  Here is a mashup of my Bunny Art toy - Dunny and Cute Sitting Skeleton models.  I have also created a new skull head specifically for this mashup.

It has a poseable head and and comes in two sizes: 6.4cm (2.5") and 8.2cm (3.2") (sitting height).  Note that the plain head, neck pin and body are exactly the same as in the original models.

There are two profiles available:

1. Skull head version
2. Plain head version

Happy printing!

Printing notes

• The standard print results in a little unevenness on the top of the leg, but this has the least amount of supports. If you want improved leg quality, but more supports to remove, then choose the “Better leg quality” plates to print.

Building Instructions

• Fit the neck pin into the body. This is designed to be tight so it takes a bit of effort to get in. If you can't use your thumb, then press it down against a table. You can usually hear a couple of clicking sounds as it goes in.
• Push the head down on to the neck pin. If there is a gap between the head and the body, then the neck pin needs to be pushed further into the body first.