R2D2
Copyright Claim
R2D2
Boost
52
108
15
Print Profile(2)
0.2mm layer, 2 walls, 10% infill
50.7 h
9 plates
0.2mm layer, 2 walls, 10% infill
2.4 h
1 plate
Open in Bambu Studio
Boost
52
108
15
2
239
32
Released
Description
Model of famous robot from Star Wars. It is not 100% original, but I hope, you enyoy printing and assebmly of it.
Print from PLA or ABS, infill 20-25%
Comment & Rating (15)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Printed without issue. Thanks for sharing.
The designer has replied
1
Reply
Looks really nice
0
Reply
how did you connecrt the feet?
0
Reply
Replying to @user_2962401566
glued them.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Nice print 👌🏼
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
I tested only the plate with all parts at the same time and the purge multiplier was set to 0... All layers had color bleed issues...
The designer has replied
1
Reply
0? my fault then, I'll change that , must have done something wrong before uploading.
(Edited)1
Reply
File is fixed now, thanks for the feedback and sorry for my mistake.
(Edited)1
Reply
Replying to @PedroMateus
no worries! It is a great model. I should have noticed it. I printed overnight so by the morning I noticed the bleeds and it was too close to finishing to stop. .
(Edited)
1
Reply
how should I connect the feet? I saw holes for something?
The designer has replied
0
Reply
I used springs and fasteners. Or glue it if you want it as static model.
0
Reply
Tried to print this as big as I could on the X1C and the feet spaghetti up any idea why?
The designer has replied
0
Reply
calibration of first layer, lower speed, flow
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
(Edited)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld