genshin-Furina浮雕 by OctopusZ

OctopusZ

Toys & Games>Characters

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

ams！0.2mm nozzle, 0.08mm layer, 100% infill，

Designer

5.2 h

1 plate

3.0(2)

Open in Bambu Studio

Boost

Released

Description

打印方式

使用100%充填，0.08层高，0.16首层打印

最开始使用黑色

在#4 (0.4mm)切换成蓝色

在#7 (0.64mm)切换成湖蓝

在#10 (0.88mm) 切换成白色

耗材使用

PLA Kexcelled Black Transmission Distance: 0.2
PLA Kexcelled Blue Transmission Distance: 3
PLA Kexcelled Lake Blue Transmission Distance: 3.6
PLA BambuLab Basic Jade White Transmission Distance: 5

不同的耗材会引入色差。

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Kexcelled Black Transmission Distance: 0.2
PLA Kexcelled Blue Transmission Distance: 3
PLA Kexcelled Lake Blue Transmission Distance: 3.6
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #4 (0.4mm) swap to Blue
At layer #7 (0.64mm) swap to Lake Blue
At layer #10 (0.88mm) swap to Jade White

genshin

Comment & Rating (2)

@joelparker1

Print Profile

ams！0.2mm nozzle, 0.08mm layer, 100% infill，

Two print attempts (no issues before or after, new hotend etc.). First was using some new but generic PLA along with Bambu. Second was run at “silent”/slow and using all new Bambu PLA basic filiment. This attempt made it to 70% before major spaghetti and bed lifting issues.

Other Issues:see my description above.