Search models, users, collections, and posts
THE ROCKMARK (Rock Bookmark) No supports needed!
IP Report
Print Profile(1)
0.2mm layer, 20% infill for bookmark, 5% infill for THE ROCK
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
24
55
1
3
56
39
Released
Description
THE ROCK IS STARING AT YOU!!!! YOU BETTER START READING!!!
Print in TPU for the best experience! (PLA also works fine)
Also PRO TIPS:
- Wait a bit after printing is finished before taking your rockmark off the hot bed (this will help prevent bending and warping of the thin bookmark).
- If you're not using my print profile, ensure the rock head has a lot less infill than the actual bookmark so it won't be too heavy on one side.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)