Modular Cable Run

Wanting to clean up the mess that is the jungle under my desk, I wanted to make something that not only cleaned it up, but improved the modularity.

This was designed with a extra long power strip in mind, but you can supply your own. Also meant for single wide strips. The long narrow channels are for cable tucking, as my plan involves custom plates for DisplayPort to run from one side to wherever my monitors will be.

Using a simple peg system, these will slide together for gluing. Keep in mind, if you pick it up upside-down it will BREAK if not glued. I made this mistake myself, knowing this.

The caps have a small trick to them, one side will need the smaller pegs to connect. Also, the boxed sides are perfect for some 40mm fans on the off chance you will house some usb controllers like me.

As for mounting, I left it blank as I intend to drill holes where I can, as the current desk is somewhat hollow with a few ribs.

The openings are sized for standard wall plates, 1 gang size. I found a website that will make custom plates: https://www.datapro.net

Enjoy!