owl hueforge
owl hueforge
Boost
20
29
8
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
20
29
8
0
67
21
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
Black Transmission Distance: 0.3
White Transmission Distance: 24
Swap Instructions:
Start with Black
At layer #3 (0.32mm) swap to White for the rest.
Comment & Rating (8)
All
Print Profile
0.08mm layer, 2 walls, 100% infill
Thanks for sharing this print profile!
My first attempt at a HueForge picture and it worked quite well.
Are we intended to change to white, and use it, on layer 3 or are we supposed to print layer 3 in black, then switch to white?
Edit:
Ran a second one for science.
On the left is white used on layer 3; on the right is white used after layer 3 (starting on layer 4).
(Edited)
The designer has replied
0
Reply
nice well done. have a look through my stuff I have a lot more and better. this was 1 of my first 1s that I had done too
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
Printed perfectly! Thank you for sharing!
0
Reply
Trying to print this but when I click print I only get the option to use one filament
The designer has replied
0
Reply
add a extra colour on your slicer on the first page you must only have 1 colour open
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld