AMS Lid Grip and Riser v2

Remixed by

AMS Lid Grip and Riser v2

Remixed by
Boost
6
7
8

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.24mm layer, 2 walls, 15% infill
0.24mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
4.5(6)

0.2mm layer, 3 walls, 20% infill 5 top/bottom layer PETG
0.2mm layer, 3 walls, 20% infill 5 top/bottom layer PETG
16 min
1 plate
4.5(2)

Open in Bambu Studio
Boost
6
7
8
0
47
28
Released

Description

This simple lid grip and riser for the AMS is an upgraded version of the original one I published. This grip fits firmly over the tab on the AMS lid so it'll stay put when you're opening and closing the lid.

 

Right side up it'll raise your lid about 10mm for larger spools and jumpers. You can also flip it upside down and use it as a grip when you want to close the lid fully.

 

Print without support. Prints in just a few minutes.

Comment & Rating (8)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 20% infill 5 top/bottom layer PETG
work very good!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Cool model
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
layed it on the back to have the least Tolerance for the grip Also put layerlines to 0.1 mm
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Alles okay
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill 5 top/bottom layer PETG
model is simple, printed easily with PETG. Works fine as a bigger handle for the lid, but I found that it doesn’t lift the lid up enough to clear my Elegoo spools with printed adapter rings, so it doesn’t really work for me. Even so, it’s. a nice model and a good idea, just not quite enough clearance for my situation.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
No more