IKEA SKADIS Desk Mount Remixed by moose_

Remixed by

moose_

Tools>Organizers

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 10% infill

Designer

5.4 h

2 plates

4.9(20)

Boost

116

269

318

212

Released

Description

A simple screw clamp desk mount for IKEA SKADIS peg boards.

Do not overtighten as it will cause the clamp to bow and warp.

If you have any feedback or improvement suggestions let me know!

Screw and screw plate modified from this model - https://makerworld.com/en/models/40989#profileId-41022

Comment & Rating (34)

@zan.bacak

Print Profile

0.2mm layer, 3 walls, 10% infill

Printed on the A1 Mini beautifully. I'll very likely print everything with Gyroid infill on the Mini since the bed lifted marginally compared to Grid. Didn't think it'd have that big of an effect since this particular model stretches diagonally across the whole bed so it's pretty impressive.

(Edited)

@JayZ

[A1] Why does the printer go back once after printing a layer? I think a lot of time was wasted.

(Edited)

The designer has replied

@moose_

this is probably because you have time lapse set in your slicer, not anything to do with this model.

@JayZ

Replying to @moose_ :

Thank you for your reply. I checked all setting of Bambu Studio(1.9.1.67), but I could't find out.

@JayZ

Replying to @JayZ :

[A1] After many experiments, I finally found the problem. Once the time-lapse photography is turned on, there will be frequent nozzle return, resulting in a decline in print quality or even failure! Hope engineers pay attention to this problem!

@yourfuturetech

Boosted

Print Profile

0.2mm layer, 3 walls, 10% infill

Nice print, I recommend adding an update to allow a single mount which can be used to hold two skadis boards side by side to allow a smaller gap between boards and save filament on printing 3 brackets instead of 4 for two skadis boards. Although this may require use of supports.

(Edited)