IKEA SKADIS Desk Mount
Remixed by
Copyright Claim
IKEA SKADIS Desk Mount
Remixed by
Boost
109
246
29
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
5.4 h
2 plates
Boost
109
246
29
1
298
200
Released
Description
A simple screw clamp desk mount for IKEA SKADIS peg boards.
Do not overtighten as it will cause the clamp to bow and warp.
If you have any feedback or improvement suggestions let me know!
Screw and screw plate modified from this model - https://makerworld.com/en/models/40989#profileId-41022
Comment & Rating (29)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
Printed on the A1 Mini beautifully. I'll very likely print everything with Gyroid infill on the Mini since the bed lifted marginally compared to Grid. Didn't think it'd have that big of an effect since this particular model stretches diagonally across the whole bed so it's pretty impressive.
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Nice print, I recommend adding an update to allow a single mount which can be used to hold two skadis boards side by side to allow a smaller gap between boards and save filament on printing 3 brackets instead of 4 for two skadis boards.
Although this may require use of supports.
(Edited)1
Reply
What is the opening width for the clamp?
The designer has replied
0
Reply
about 33mm / 1-5/16in when fully open
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
The designer has replied
0
Reply
any issues?
0
Reply
Replying to @moose_
The model worked well but the fitting between the screw and the "plate" had somewhat tight tolerances. Might have been an issue on my end though.
0
Reply
Replying to @Wackosaurus
Ok thanks I will fix that if I hear about this again
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
passt perfekt. ist stabil genug um werkzeug für den 3d Drucker aufzuhängen
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
works well. Golding the board strong.
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 10% infill
Perfect!!! 👍👍. Thanks 🙏
0
Reply
Boosted
Thanks, your model is amazing and works very well! ;)
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Gute Alternative, wenn man nicht in die Wand bohren will oder kann.
Allerdings sollte man nicht zu Schwere Gegenstände anbringen die das Board kippen könnte. Sicher ist sicher 👍
0
Reply
clean =)
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld