Broom and dustpan set
Copyright Claim
Broom and dustpan set
Boost
53
88
50
Print Profile(2)
BROOM ( no Support) 0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
PALLET 0.2mm layer, 4 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
53
88
50
1
147
81
Released
Description
ATTENTION:
Broom no need support
Cut the part blocking the bristle with a cutter
To block the pin use glue
Comment & Rating (50)
All
Print Profile
BROOM ( no Support) 0.2mm layer, 2 walls, 15% infill
A little bit of filament color in the middle got crossed, but it could have been a machine error
The designer has replied
0
Reply
optimize printing and reprinting and remember to give me 5 stars, thanks :-)
0
Reply
Print Profile
BROOM ( no Support) 0.2mm layer, 2 walls, 15% infill
printed good. but while cutting out the excess lot of uneven cuts. but overall usable and great model nonetheless.
The designer has replied
0
Reply
did you use a very sharp cutter to cut the excess part?
0
Reply
Print Profile
BROOM ( no Support) 0.2mm layer, 2 walls, 15% infill
super easy to put together & super cute!
The designer has replied
0
Reply
Thank you for great rating
0
Reply
Print Profile
BROOM ( no Support) 0.2mm layer, 2 walls, 15% infill
TOP
The designer has replied
0
Reply
Thank you for great rating
0
Reply
Print Profile
PALLET 0.2mm layer, 4 walls, 15% infill
The designer has replied
0
Reply
Thank you for great rating
0
Reply
Very nice Design Francesco! 👍
The designer has replied
0
Reply
Thank you for great rating, you forgot to put stars on me 🙏
0
Reply
Replying to @FrancescoM
It‘s only possible to rate with stars after the modell has been printed.
0
Reply
the broom was so hard to cut it ended up uneven and the little pieces attached to it are falling off 😭😭
(Edited)The designer has replied
0
Reply
use sharp scissors you will succeed with just one shot
0
Reply
Print Profile
PALLET 0.2mm layer, 4 walls, 15% infill
don’t know why the stick to attach broom with dustpan is missing…🥲
The designer has replied
0
Reply
the paddle stick is attached to the paddle I will send you photos of the file inserted on makerword
(Edited)
0
Reply
Print Profile
BROOM ( no Support) 0.2mm layer, 2 walls, 15% infill
thanks
The designer has replied
0
Reply
Thank you for great rating
0
Reply
Print Profile
BROOM ( no Support) 0.2mm layer, 2 walls, 15% infill
super Model war etwas schwierig die börsten zu schneiden
0
Reply
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld