FAST HueForge Frame 250x250

FAST HueForge Frame 250x250

Boost
9
9
2

Print Profile(1)

All
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
5.0(1)

Open in Bambu Studio
Boost
9
9
2
3
9
3
Released

Description

Boost Me (for free)

If you like my models and want to support me, please consider donating a Boost! I would be very grateful!🤗

Very fast print, and the HueForge print pops rights in! No additional pieces needed to print separately to hold the picture in place.

 

Has spots to easily hang on the wall.

 

PLEASE READ! IMPORTANT!!
- REMOVE the prime line right after it lays it down (the little strip on bed right before it starts printing the model) 
- This print utilizes the ENTIRE border of the 256mm bed size.
- It prints on the very edge of the plate, where your thumbs normally touch the plate.
- So please make sure your sides are CLEAN, CLEAN, CLEAN before starting the print! Or you may have adhesion issues!
- Again, REMOVE prime line as soon as you can or the frame will print on it making imperfections.

 

If you are looking for the 150x150 Frame, you can check it out here:
https://makerworld.com/en/models/867172#profileId-818504

 

If you are looking for the 150x200 or 200x150 Frame, you can check it out here:

https://makerworld.com/en/models/924027#profileId-886657

 

If you are looking for the 200x200 Frame, you can check it out here:
https://makerworld.com/en/models/823744#profileId-767187

 

If you sell HueForge prints, you are more than welcome to sell this frame with them!

 

Happy Printing!

 

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
I had an unusual sized print that needed a frame and was able to scale this one to work perfectly (250x167). My only request would be to add a stand like you did with your other frames 🙂 Thanks!
0
Reply
Thank you so much for creating a model for this size!
0
Reply
No more