Makita charger wallmount
Copyright Claim
Makita charger wallmount
Boost
105
252
87
Print Profile(2)
0.2mm layer, 6 walls, 100% infill
Designer
1.2 h
1 plate
0.2mm layer, 6 walls, 100% infill
1.2 h
1 plate
Boost
105
252
87
12
495
570
Released
Description
A simple mount for the most common Makita charger.
Just remove the four rubber feet and press the charger down onto the pegs on the mount, simple as that.
Can be mounted in all directions due to being press fit.
Questions are welcome and please like, rate and share.
Comment & Rating (87)
All
Boosted
Print Profile
0.2mm layer, 6 walls, 100% infill
great print! Fitts perfect
The designer has replied
0
Reply
brilliant use of it 🙂
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 100% infill
super
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 100% infill
Works perfectly. Thank you
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
sehr gut druckbar
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
nice mount for the Makita charger.
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
The designer has replied
0
Reply
looking good :)
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
printed three times, but it always breaks at the edges.
The designer has replied
0
Reply
Hi @GingerCatLady
I’m sorry to hear that.
Does it break during the print?
Can you post any pictures of the break?
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld