Egg - Saver by laisch

laisch

Household>Other House Models

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

Standard

Designer

1.3 h

1 plate

4.8(9)

Open in Bambu Studio

Boost

Released

Description

Now you can transport your delicous egg without the fear of crushing it!

Printing:

This is a print in place model.
Activate supports, but block it on all the hinges, otherwise they can bind up.

Postprocessing:

Remove the supports and clean up the little tabs on the buckles.

Comment & Rating (13)

@wikitinl2

tried this print 3x, every time, same issue on the tab exactly the same

The designer has replied

@laisch

Hi, seems like there is some problem with bed adhesion and the clip got knocked over during the print. I had the same issue on the first iteration, that's why I added these sacrificial tabs to give it more surface for the bed since I wanted to avoid a brim. You can still try it with a brim, but you have to clean up more afterwards.

@robjohna

Same issue here. Weird tab printed offset. Same tab on two occasions. Otherwise it's a great conceptual design.

@PenguinGod

Print Profile

Standard

Good for easter hunts

@Kirdae

Boosted

very nice model!

@DaCa86

Print Profile

Standard

Ich habe 2 Eier gleichzeitig gedruckt und bei beiden das Problem, dass das kleine Teil zum einrasten, nicht richtig gehaftet hat und sich leicht verschoben hat.